Container Pallet Calculator
How many pallets fit in a 40GP or 40HQ
Exact-geometry load planning for 40 ft standard and high-cube containers: floor positions on the standard straight layout, turned and pinwheel maximums, stacked totals and floor utilization, with a load diagram. For trailers, see the Pallet Load Calculator.
GP and HQ share the same floor interior (about 474 in × 92.7 in), so floor positions are identical. They differ in interior height (about 7.85 ft vs 8.85 ft), which only affects how many layers can stack.
Interior height is about 7.85 ft in a GP and 8.85 ft in an HQ: freight over about 4 ft per pallet usually stays single-layer in a GP, while an HQ may fit two layers. Stacking also needs crush strength in the bottom cartons and total weight within limits.
Load diagram (top view, blue = straight, orange = turned)
Results are rule-of-thumb industry estimates for planning only — not a quote, design or investment basis.
The container arrives — receiving should not run on paper
Try Docklify: container receiving, QC, putaway and outbound loading tracked in one flow, with container, pallet and location tied together.
Explore DocklifyHow many pallets fit in a 40 ft container: the short answer
On a 474 in × 92.7 in floor: GMA 48×40 pallets fit 18 straight and up to 19 pinwheeled; Euro 1200×800 pallets fit 20 straight. Those are floor positions — double them only if the freight can actually stack two layers and the total stays under the weight limit. Switch the specs above and this tool re-plans the layout and draws it.
GP vs HQ: no difference on the floor
A 40GP and a 40HQ have identical interior length and width; only the height differs (about 7.85 ft vs 8.85 ft). Container choice therefore changes stacking layers and maximum load height, not floor positions. Freight between roughly 4 and 4.4 ft tall that can bear stacking is where an HQ earns its premium; for single-layer or tall freight, both boxes load exactly the same.
Two more checks before you load
First, weight distribution and securing: heavy freight at the door end travels badly — see the loading guide below for distribution and bracing rules. Second, the weight limit: a 40 ft container commonly caps around 26–28 tonnes payload (check the door plate and carrier rules), and dense freight like tile, stone or beverages hits the weight ceiling before the floor is full.
Related guides
- How many pallets fit in a 40 ft container (guide)
- Container loading: weight distribution & securing
- Container unloading operations guide
FAQ
How many standard pallets fit in a 40 ft high cube?
GMA 48×40: 18 straight, up to 19 pinwheeled. Euro 1200×800: 20 straight. This tool plans the geometry from the interior dimensions, so its numbers match the spec switches above.
Why do some sources say 24–26 pallets in a 40 ft?
That usually comes from column-mixed load plans, where the two orientations interlock inside one cross-section and pack tighter than the row layouts this tool plans — or from floor-loaded freight counted without pallets. Align pallet spec and layout method before comparing numbers. This tool uses the row layouts that forklift loading actually follows.
Is pinwheel loading worth it?
It buys 1–6 extra floor positions at the cost of longer loading time and a more experienced crew. On high volume or expensive freight lanes it pays; for an occasional container, straight loading is faster and the saved positions rarely change the freight bill.
Does a 53 ft trailer hold more than a 40 ft container?
Yes — a 53 ft trailer is about 630 in long inside and fits 26 GMA pallets straight, roughly 40% more than a 40 ft container at 18. If your chain mixes domestic trailers with ocean containers, plan the two legs on their own numbers; the trailer version is under related tools.
